Name Of Parts And Operation Selector Switch - Technibel Climatisation MRAF98R5I Série Notice D'utilisation

NAME OF PARTS AND OPERATION SELECTOR SWITCH

1. Remote control unit.
2. Sensor: Detects the room temperature around the
remote control unit, the air conditioner is controlled
accordingly.
3. Air outlet : distributes filtered and treated air into the
room.
4. Receiver : receives signals transmitted from the remote
control.
5. Operation selector (without remote control): Push
the button to walk through the OFF, COOL and HEAT
operation modes.
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
6. OPERATION lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored.
5
4
6
8
7
7. STANDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
8. TIMER lamp: This lamp lights up when the system is
being controlled by the timer.
NOTES
It is possible to set the air conditioner in order to let
●
the OPERATION, TIMER and STANDBY lamps always
OFF, even during operation.
Press contemporary the IFEEL and FAN buttons on
the remote control unit for more then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
In case of troubleshooting the air conditioner
●
diagnostic system activates the lamps accordingly,
even if they are set to OFF. See paragraph
TROUBLESHOOTING for further details.
3
3
2
1
EG