Product Description; Use - Life & Mobility MATCH AURA Mode D'emploi

Inspired by life

Product description

Checking the delivery
Before using the push assist, check if the
delivery matches the product description
below. If you find any transport damage on
delivery, please inform your dealer.
Life & Mobility trusts that the push assist
meets your expectations and hopes it brings
you much convenience.
Product description
Push assist
A. Control unit control panel
B. Control unit control lever
C. Charger connection point
D. Battery switch
E. Wheel with propulsion motor
F. Free-wheel lever (small black lever)
G. Housing for controller and battery
H. Battery
Control panel
I. Selection switch
J. Speed setting 1 to 4
K. Indoor setting
L. Off position
M. Battery indicator
Not pictured
n Battery charger with connection cable
The battery on delivery
The battery of the wheelchair is charged on
delivery. This means that the wheelchair is
ready to use. It is possible that the battery is
not fully charged because it has discharged
partially during storage and transportation.
EN14
A
B
C
D
H
E
F
G
Product description
J
3
I
K
L
M
Control panel
'Off' position
Indoor setting
3
Speed position 1
Starting and setting speed
The battery has a switch to turn off the
3
push support, for example, to prevent
unintentional use. Turn on the switch to move
(the red light on the switch is now on).
The Aura push assist is provided with a
selection switch for switching the push assist
on and off. You can also select the maximum
speed with this switch.
'Off' position
The push assist is switched off. The
wheelchair's parking brake is activated.
Indoor setting
The push assist is switched on. The driving
speed and acceleration are limited for use
indoors and for manoeuvring in small spaces.
Speed setting 1 to 4
The push assist is switched on. The maximum
driving speed can be set from approximately
2 km/hour (position 1) to approximately 6 km/
hour (position 4)
Tip: If required, the dealer can adjust the
speed and acceleration.

Use

EN15