Installation Instructions; Symbol Description; Flow Diagram - Hansgrohe Talis S2 Variarc 14872000 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to
prevent crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for
transport damages. After it has been installed, no
transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
Technical Data
This mixer series-produced with EcoSmart
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking
water!
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
Assembly (see page 31)
English

Symbol description

Do not use silicone containing acetic
acid!
Adjustment (see page 33)
To adjust the hot water limiter. Using a
hot water limiter in combination with
a continuous flow water heater is not
recommended.
Dimensions (see page 36)

Flow diagram

(see page 37)
® 

Operation (see page 34)
Hansgrohe recommends not to use
as drinking water the first half liter of
water drawn in the morning or after a
65°C
prolonged period of non-use.
Cleaning (see page 38)
If the waterflow drops, clean the filter
located between hose and handspray.
Spare parts (see page 40)
Maintenance (see page 39)
The check valves must be checked
regularly according to DIN EN 1717 in
accordance with national or regional
regulations (at least once a year).
Normal spray
Regular