Installation Instructions; Flow Diagram; Adjustment - Hansgrohe Talis S 200 72813000 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fitting must be installed, flushed and tested after
the valid norms.
• The plumbing codes applicable in the respective
countries must be oberserved.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!

Adjustment

To adjust the hot water limiter on single lever
mixers, please see page 35. Using a hot
water limiter in connection with a continuous
flow water heater is not recommended.
4
English
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 70°C
65°C
max. 70°C / 4 min
Assembly see page 31
Dimensions (see page 36)

Flow diagram

(see page 36)

Rate of flow Normal spray

Handspray flow rate
Operation (see page 37)
• Do not rotate the spout further than 360º
or damage to the hose will result.
• Hansgrohe recommends not to use
as drinking water the first half liter of
water drawn in the morning or after a
prolonged period of non-use.
Cleaning (see page 38) and
enclosed brochure
Maintenance (see page 38)
The non return valves must be checked
regularly according to DIN EN 1717 in
accordance with national or regional
regulations (at least once a year).
Spare parts (see page 39)
XXX = Colors
000 chrome plated
800 stainless steel optic