Check Before Use - KRATOS SAFETY LA 10250 10 Notice D'utilisation Et D'entretien

First, you should read carefully the information indicated on the instructions for use. These instructions have to be carefully kept and
have to be made available to installers and users of the device. KRATOS SAFETY load arresters are intended to stop the fall of a load (as
a basketball hoop, a ramp lighting...) for a short distance in case of:
- Break of the chain or the cable used for lifting the load,
- Failure of the retaining elements of the load.
1. Check that the load capacity corresponds to the load to ensure.
2. Check the status of the device and of the anchorages before each use.
3. In case of doubt, it is important to not use the device. Please return each device having a defect to KRATOS SAFETY.
4. Each device which has stopped a fall has to be returned for a full checking.
5. You should be informed of the conditions of use of a KRATOS SAFETY load arrester by referring to the instructions for use.
6. You have to use one device by load.
7. Never use a load arrester for a person.
8. Number of cycles a day has to be less or equal to 60.
9. Never stay under the load during the working of the device or after a fall arrest.
The wire rope is constantly tense thanks to a retractable system integrated to the device. In case of the fall of the load, blocking systems
come into action to stop the fall, and then the braking system comes into action to brake and stabilize the load.
Both systems (blocking & braking) working instantly, the load is stopped and stabilized in an extremely short time.
Please anchor the device in the vertical axis of the load by using the rotary anchor ring of the device, be sure that the anchor which has
to support the device and the load has a minimum resistance of 25 KN. Connect the load to ensure with the wire rope end.
Be sure that the points below are well respected:
1. Position the load arrester in the vertical axis of the load.
2. Check that no element rubs on the wire rope.
3. Check that no obstacle interferes with the winding and the unwinding of the wire rope.
4. Check that the descending speed of the load is compatible with the blocking speed of the device
5. Check that the free distance under the load is compatible with the requested distance for a fall arrest.
1. Check the retractable system of the wire rope by unwinding it completely and check that the return of the wire rope is done in its
totality. BE CAREFUL, always accompany the wire rope by slowing it.
2. No wear or deformation over the entire length of the wire rope.
3. Check at the beginning, at the middle and at the end of the wire rope the blocking of the wire rope unwinding by pulling firmly on
the wire rope end.
4. No wear of the anchors on the device and on the load.
INSTRUCTIONS
WORKING
INSTALLATION

CHECK BEFORE USE

GB