Network Setup - Samsung HT-J5500 Mode D'emploi

Settings
To show the RDS signals
You can see the RDS signals the station sends on the
display.
Press the
RDS DISPLAY
FM station.
~ Each time you press the button, the display change
to show you the following information : PS NAME
 RT  CT  Frequency
While searching, <PS NAME>
appears and then the station
PS (Program
names will be displayed.
Service)
<NO PS> appears if no signal is
sent.
While searching, <RT> appears
and then text messages the
station sends will be displayed.
RT (RadioText)
<NO RT> appears if no signal is
sent.
Station frequency (non-RDS
Frequency
service)
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
~ The display window cannot differentiate upper case
and lower case letters and always uses upper case
letters.
~ The display window cannot show accented letters,
<A,> for instance, may stands for accented <A's>
like <À, Â, Ä, Á, Å and Ã.>
PTY (Program Type) indication and
PTY-SEARCH function
One of the advantages of the RDS service is that
you can locate a particular kind of program from the
preset channels by specifying the PTY codes.
To search for a program using the PTY codes
~ Before you start!
- The PTY Search is only applicable to preset
stations.
- To stop searching any time during the process,
press 5 button while searching.
- There is a time limit in doing the following steps.
If the setting is cancelled before you finish, start
from step 1 again.
button while listening to an
22
- When pressing the buttons on the primary
remote control, make sure that you have selected
the FM station using the primary remote control.
RDS DISPLAY
1
PTY -
4
Press the
1. PTY SEARCH
to an FM station.
Press the or
2. PTY-
code you want appears on the display.
~ The display gives you the PTY codes
described to the right.
Press the
3. PTY SEARCH
PTY code selected in the previous step is still on
the display.
~ The centre unit searches 15 preset FM
stations, stops when it finds the one you have
selected, and tunes in that station.

Network Setup

When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.
Configuring Your Network Connection
To begin configuring your network connection, follow
these steps:
1. In the Home screen, select Settings, and then
press the E button.
2. Select Network, and then press the E button.
3. Select Network Settings, and then press the
E button.
4. Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks on the right of next page.
- English
+
TA
2 3
PTY SEARCH PTY +
5 6
button while listening
button until the PTY
PTY+
button again, while the