How To Prepare The Machine For Operation; How To Install The Batteries - Alto CLARKE FUSION 20I Manuel D'utilisation

BATTERY CONNECTIONS
To machine
power plug
Front of Machine
Figure 13
CONEXION DE LAS BATERIAS
Hacia el enchufe de
alimentación de la
máquina
Parte delantera de la máquina
Figura 13A
CONNEXIONS DES BATTERIES
Vers la fiche
d'alimentation
de la machine
Avant de la machine
Figure 13B
Figure 14
Page -24-

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Batteries

The Fusion 20 machines use three 12-volt batteries.
The batteries are located in the battery compartment
under the battery cover.
To Install the batteries, follow this procedure:
1. Set the parking brake.
2. Remove the battery cover.
3. Remove the two screws that attach the
main body to the back of the frame, leaving
the two angle brackets attached to the main
body.
4. Remove the hose from the pad housing.
5. Remove the main body.
6. Place the batteries in the tray as shown in
figure13
WARNING:
WARNING:
7. Connect the battery cables between
batteries as shown. See figure 13.
8. Join the connector from the battery pack to
the connector on the control panel. See
figure 14.
9. Reassemble machine.
NOTE: Charge the batteries before using the
machine.
CLARKE TECHNOLOGY Operator's Manual -Fusion 20 Burnisher
Lifting batteries without
help could result in an
injury. Get help to lift the
batteries. The batteries are
heavy.
Working with batteries can
be dangerous. Always
wear eye protection and
protective clothing when
working near batteries.
NO SMOKING!