Wr2 Components; Wr2 Benefits; Mounting The Controller Interface - Rain Bird WR2 Wireless Sensor Manuel De L'utilisateur

WR2 Components

1
Controller Interface
2
Sensor
3
Battery Cassette and Lithium CR2032 Battery
4
5
6
User's Manual
7
Quick Reference Guides
8
1
5
6
NOTE: Tools needed for installation: drill, drill bit, and
Phillip's head screwdriver
2
WR2 Wireless Sensor
2
3
4
7
Rain Bird's Wireless Rain or Rain / Freeze Sensor
Quick Reference Guide Guía de referencia rápida
!
DO NOT insert battery cassette into Sensor until Controller
Interface is powered up and you are ready to "pair" the units.
No inserte las pilas en su compartimento hasta que se encienda el sensor
del interfaz del programador y este preparado para sincronizarlos.
1
Controller Interface - Mounting
Montaje de la interfaz del Control WR2
Cable length
30" (76.2 cm) 8
Longitud del cableado
30" (76.2 cm)
2
Controller Interface - Wiring
Instalación del cableado entre la interfaz de control
RED ROJO - 24VAC
BLACK NEGRO - 24VAC
WHITE BLANCO - Sensor Input (or Common) Entrada para sensore (o Common)
GREEN VERDE - Sensor Input (or "Field") Entrada para sensore (o "Field")
3
Controller Interface -
Initial Power Up
Interfaz de control -
Puesta en marcha
inicial
4
Pair Controller Interface & Sensor
Sincronización del sensor y la interfaz del Control WR2
1 4
2
3
blink
Intermitente
5 Programming Set Points
Programación de los niveles preestablecidos
2
1

WR2 Benefits

All settings are programmed through the Controller
Interface device
Large easy to understand icons communicate irrigation
mode and sensor status.
reducing installation time
Battery is easy to install / replace
flat surfaces or rain gutters
"Quick Shut Off" interrupts active irrigation cycle during
a rain event
Enhanced antenna array provides superior signal
Mounting the Controller
1
Interface
Choose a location near the irrigation
controller / timer.
!
The cable harness is 30 inches (76.2 cm)
long, so before mounting the device,
ensure the wires easily reach the irriga-
tion controller's connection terminals.
Select a flat surface adjacent to the irrigation controller.
It is recommended that the
maximize communication range.
supplied. Attach the Controller