Parkside PMSHM 2 A1 Instructions D'utilisation Et Consignes De Sécurité page 30

Note: When measuring under the measure-
ment range, the display shows "0.0%"
8
or "Lo". For measurements above the meas-
urement range, the display shows "Hi".
8
Remove the protective cap .
1
Press both measuring pins against the
2
surface at the same time. After 1–2 seconds
you can read the percentage value.
If you are taking a measurement in an area in
which you cannot read the display , press
8
30 GB/IE