Vox DelayLab Manuel D'utilisation page 5

5 . WRITE button
Use this button to save the effect settings to a program.
)Page 9 "Saving edited effects"
6 . CANCEL button
Press this button when you want to cancel an operation such
as saving a program.
You can disable the top panel buttons, knobs and selectors
by holding down this button for approximately two
seconds (Page 14 "Key Lock function"). To cancel the Key
Lock function, hold down this button once again for
approximately two seconds.
7 . PEDAL ASSIGN button
Press this button to set the external expression pedal
settings.
When the parameter operation is set by the pedal, the LED
lights up red. Also, the LED lights up green when setting the
pedal settings.
)Page 11 "Using a connected pedal"
8 . Type Selector knob
Use this knob to select the effect type.
9 . Edit knobs
a . TIME knob
Use this knob to set the delay time.
b . FEEDBACK knob
Use this knob to set the delay feedback volume.
c . TONE/SPEED knob
The effect may vary according to the delay type. See the
Parameter chart (Page 82) to determine the function.
d . INTENSITY knob
The effect may vary according to the delay type. If the
Looper is selected, use this to set the loop level (loop
volume).
e . MIX knob
Use this knob to set the volume balance of the delay sound
and direct sound.
10 . TAP/BANK UP (REC/PLAY/OVERDUB) switch
Use this switch to set the delay time. The interval used when
pressing the TAP/BANK UP switch two times will be set as
the delay time, and the LED will blink in green. When SYNC
is on, tempo (BPM) appears on the display and the LED
blinks in red.
Press and hold this switch for 2 seconds to select another
bank.
The bank that you are selecting will be blinking on the
display. The bank (1–10) switches each time the TAP/BANK
UP switch is pressed.
If the switch is pressed and held for 2 seconds again, the
switching of the bank is canceled.
When "LOOPER" is selected on the Type Selector knob, this
switch becomes the REC/PLAY/OVERDUB switch.
)Page 10 "Using looper effects"
5