Setting The Bypass Sound - Vox DelayLab Manuel D'utilisation

VOX DelayLab Owner's manual
If the Type Selector knob is used, the pedal setting is
canceled and the PEDAL ASSIGN LED is turned off.
When the LED is green, the parameter controller can
be canceled by pressing the CANCEL button while
using the Edit knob.
If the delay time is set to be controlled with a pedal,
the settings are canceled if the SYNC button is
pressed.
Adjusting the sensitivity of the control pedal
When the connected pedal is pressed and the effect and
volume are not maximized or when the pedal is released
and the effect and volume are not minimized, use the
DelayLab as follows to adjust the sensitivity of the pedal so
that it can be used to its full potential.
When adjusting the sensitivity, be sure to use the pedal
with your foot. If you use the pedal with your hands, the
sensitivity of the pedal may not be adjusted properly.
1.
Press and hold the CANCEL button and PEDAL
ASSIGN button and connect a cable to the INPUT (L/
MONO) jack.
2.
When "PdL" appears on the display, release the buttons.
3.
When "PdL _ " appears on the display, slowly release the
pedal with your foot, remove your foot when it stops
and press the WRITE button.
12
When "PdL – " appears on the display, lightly press
4.
the control pedal and remove your foot at the stopped
position. To cancel the sensitivity adjustment, press the
CANCEL button.
5.
Press the WRITE button.
"127" appears on the display. If the pedal is rocked back
and forth, the value will change smoothly from "0" to
"127". Once the procedure is verified, press the WRITE
button.
When the sensitivity cannot be adjusted, "Err" appears
on the display. When this occurs, perform the procedure
from step 4.
The unit may be malfunctioning if the procedure is
repeated and the sensitivity cannot be adjusted. If this
occurs, please contact your nearby VOX dealer.

Setting the bypass sound

When you want to turn off (bypass) an effect, select the
bypass sound from the following 2 sounds.
DSP bypass
Use this to send the output signal that is coming from DSP
via A/D and D/A.
1.
Press and hold the CANCEL button and Channel switch
C and connect a cable to the INPUT (L/MONO) jack.