Sensor Mounting Instructions; Using Multiple Controller Interface Units - Rain Bird WR2 Manuel De L'utilisateur

Sensor Mounting
Instructions
This section provides detailed ins-
tructions on how to install the sensor.
Sensor Bracket Assembly
Components:
Attachment
Bracket
Attaching the bracket to a
gutter.
Slide the top portion of the attachment
bracket over the lip of the gutter. Rotate the
bracket downward over the gutter as shown
in the following installation steps.
■
1
mounting
bracket gutter
Attaching the bracket to a
Flat Surface.
Use the
supplied
hardware to
mount the
attachment
bracket to a
flat surface
such as a wall
or fence.
8
WR2 Wireless Sensor • www.rainbird.com/WR2
WR2 user manual (637469-01) EN ESMX FRCA.indd 8
Installing the Sensor in the
attachment bracket.
To insert the Sensor in the attachment bracket
you must first remove the Sensor cap. Hold
the sensor body in one hand; gently twist
the cap with your other hand. Slide the neck
of the sensor up through the opening of the
extension arm. Reinstall the cap. A clicking
sound indicates that the two latches on the
sensor body have fully re-engaged the cap.
Extension
Arm
■
2
Up to four (4) Controller Interface units can be
paired to one (1) sensor.
1. Ensure all Controller Interface Units are
2. Synchronize the Sensor to the first
3. As you approach the second Controller
■
1
Remove Cap
■
3 Replace Cap
Using Multiple
Controller Interface
Units
powered up.
Controller Interface in accordance with
Section .
Interface, remove the battery cassette
from the Sensor. Push both arrow buttons
simultaneously on the second Controller
Interface. Wait 5 seconds. Reinsert the
■
Insert
2
2/23/2018 8:09:26 AM