Product Description - Sharp LL-T2010W Mode D'emploi

Control Panel
1. INPUT button . . . . . . . . . . . . . . To switch between the signal's input terminals. (Analog RGB input
2. MENU button . . . . . . . . . . . . . . . This button is used to pop-up, select and close the OSD Menu.
3. SELECT button . . . . . . . . . . . . . This button is used to select menu options when the OSD Menu is
4. buttons . . . . . . . . . . . . . . . When the On Screen Display (OSD) Menu is displayed:
5. Power LED . . . . . . . . . . . . . . . . This LED is lit green when in use and orange when in power-saving
6. Power button . . . . . . . . . . . . . . . Pressing this button turns the power on. (After turning the power on,
Adjusting the angle of the monitor
Lightly holding both sides of the monitor, adjust it to
a suitable viewing angle.
CAUTION!
- Pressure from hands on the LCD panel could
cause damage.

Product description

Front view
terminal ↔ DVI-I input terminal)
displayed.
These buttons are used to increase or decrease the value of a
selected option.
When the OSD Menu is not displayed:
These buttons are used to adjust backlight brightness .
mode.
it may take a little time before the screen displays.)
Press the button again to turn the power off.
10
approx.30°
approx.45°
approx.5°
approx.45°