LD Systems LD SAT Série Manuel D'utilisation page 10

OPERATINg INfORMATION:
lD SUB88A
MoUnTIng / InSTAllATIon
The powered system LD SUB88A can be either installed on ground or on a solid base with adequate load capaci-
ty. It is strictly recommended to install the LD SUB88A not in a height above 150 cm (risk of drop down). The LD
SUB88A can be installed either in horizontal positon or upright.
Please check for enough distance (> 20 cm) between integrated amplifer and walls, racks etc. to prevent over-
heating for sure. Especially if installed in a shelf or inside a bar etc.. It is important to take care for an adequate
ventilation of the integrated amplifier. Please take care for a accurate wiring for the power wiring as for the input
wiring. Please use only undamaged cables of an adequate size as well as only completely unrolled cable reels.
Please check the wiring for any kind of trip hazard etc. to prevent any kind of accident or damage.
Please do not install the items directly beside an edge like the border of the base.
connEcTIng AnD oPERATIng
To connect the LD SUB88A the device should be turned to OFF. There is a connection using 6.3 mm jacks (ba-
lanced triple pole / unbalanced two pole) possible as well as a balanced connection using triple pole XLR plugs.
After connecting all necessary cables and the MAIN LEVEL adjust is turned counterclockwise the source device
can be turned to on. Then the LD SUB88A can be turned to ON too. Please turn the MAIN LEVEL adjust clockwise
until designated level is reached. Using the SUB CROSSOVER adjust the frequency range can be limited to match
the LD SUB88 A with the used satellites. Also the PHASE switch can be used in combination with satellites if ne-
cessary. Please use switch position with the best sound. The Connection and operating elements of LD SUB88A
are shown on the back panel active speakers page. It is recommended to switch the system to ON as the last
one and to OFF as the first one to prevent start-up noise caused by a connected device like a mixer etc..
lD SUB10A
MoUnTIng / InSTAllATIon
The powered system LD SUB10A can be either installed on ground or on a solid base with adequate load capaci-
ty. It is strictly recommended to install the LD SUB10A not in a height above 150 cm (risk of drop down).
Please check for enough distance (> 20 cm) between integrated amplifer and walls, racks etc. to prevent over-
heating for sure. Especially if installed in a shelf or inside a bar etc.. It is important to take care for an adequate
ventilation of the integrated amplifier. Please take care for a accurate wiring for the power wiring as for the input
wiring. Please use only undamaged cables of an adequate size as well as only completely unrolled cable reels.
Please check the wiring for any kind of trip hazard etc. to prevent any kind of accident or damage.
Please do not install the items directly beside an edge like the border of the base.
connEcTIng
To connect the LD SUB10A the device should be turned to OFF.. It can be uses as an additional bass wuth full-
range speakers (Stinger 8" oder Stinger 10") or be implemented for installation applications. This subwoofer
features an integrated 3-channel power amplifier ( 3x 120 W RMS) allowing the connection of additional passive
full-range speakers, or of installation speakers such as the LD SAT series speaker.
10