Dometic WAECO PerfectPower PP152 Instructions De Montage Et De Service page 19

Masquer les pouces Voir aussi pour WAECO PerfectPower PP152:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
PerfectPower
2.2
Safety when installing the device
WARNING!
!
 Never connect more than one consumer device to the inverter.
If you connect more than one device, a short circuit may occur.
CAUTION!
!
 Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
 Take the precautions necessary to ensure that children cannot
interfere with operation. Dangerous situations may occur which
cannot be recognised by children!
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
Electrical cables
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or wire bushings to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Fasten the cables securely.
 Lay the cables so that they cannot be tripped over or damaged.
2.3
Operating the appliance safely
WARNING!
!
 Note the following basic safety information when using electrical
devices to protect against:
– Electric shock
– Fire hazards
– Injury
 Do not operate the device near gas or flammable material; the
surface temperature can reach up to 60 °C.
EN
General safety instructions
19

Publicité

Table des Matières
loading

Table des Matières