Mounting Hose Clamp; Adjustment Of Spring Tension; Maintenance; Repair Instructions - Nederman 883 Série Manuel De L'utilisateur

7 Fit the reel, see
EN
and Chapter 5 Connection to the pipework
8 Check that the required length of hose can be un-
reeled without stretching the spring to its limit.
9 Turn on the supply and check that the hose con-
nections do not leak.
9 Mounting hose clamp
See Figure 10.
10 Adjustment of spring tension
See Figure 7.
• Increasing the spring tension.
• Decreasing the spring tension.
If the spring power has been increased check that the
required length of the hose can be drawn out without
stretching the spring to the limit.
11 Maintenance
See Figure 8. The following maintenance is recom-
mended to be accomplished regularly or at least once
a year.
• Check the spring function by testing if the hose re-
coils properly.
• Check that swivel and hose couplings do not leak.
Change the seal if required. Clean the swivel and
couplings.
• Check that the hose is intact. Clean the hose if it is
oiled or dirty.
• Check the reels ratchet mechanism.
• Check the mounting of the reel on the wall or ceiling.
Read Chapter 5 Connection to the pipework system
before carrying out maintenance.
11.1 Repair instructions
WARNING! Risk of personal injury
Before starting any operation in the reel:
• Turn off the supply of air/water/oil/grease.
• Neutralize the spring power by removing the
hose-stop and let the hose recoil.
Instructions for hose fitting, see
ting. Instructions for changing the spring cassette,
swivel or seal comes with each spare part.
12 Spare Parts
CAUTION! Risk of equipment damage
Use only Nederman original spare parts and ac-
cessories.
Contact your nearest authorized distributor or
Nederman for advice on technical service or
if you require help with spare parts. See also
www.nederman.com.
14
Hose Reel Series 883
Chapter 4 Mounting instruction
Chapter 8 Hose fit-
12.1 Ordering spare parts
system.
When ordering spare parts always state the following:
• The part number and control number (see the
product identification plate).
• Detail number and name of the spare part (see
www.nederman.com/en/service/spare-part-
search).
• Quantity of the parts required.
13 Recycling
The product has been designed for component mater-
ials to be recycled. Different material types must be
handled according to relevant local regulations. Con-
tact the distributor or Nederman if uncertainties arise
when scrapping the product at the end of its service
life.