Using The Control Box; Manual Operation; Automatic Operation - Dometic PERFECTVIEW Switch 300 Notice D'utilisation

SWITCH300
7

Using the control box

7.1

Manual operation

You can operate the control box manually. To do this, fit the two-stage switch (fig. 3 4, page 3)
supplied to a suitable place on the dashboard and connect it to the black/red and white cable.
With manual operation, you activate a particular camera by hand via the three-stage switch
(fig. 3 3, page 3) supplied.
In manual operation, a switch signal is sent via the blue cable which can activate the monitor.
➤ Place the two-stage switch in the required position to switch on the corresponding camera:
– I: manual operation is switched on
– 0: manual operation is switched off (the three-stage switch does not have a function)
➤ Connect the cables of the three-stage switch (fig. 3 3, page 3) according to the assignment
on page 12.
➤ Place the three-stage switch in the required position to switch on the corresponding camera:
– B: reversing camera (CA1) (fig. 6 1, page 5)
– L: left camera (CA2) (fig. 6 2, page 5)
– R right camera (CA3) (fig. 6 3, page 5)
I
NOTE
There is no signal on the control cable of the monitor during manual operation when
the switch is connected.
7.2

Automatic operation

You can operate the control box in automatic mode. In the automatic mode the cameras switch on
or off automatically according to the control signal present. The monitor is activated automatically
via the control box.
I
NOTE
During automatic operation a signal of +12 V is present on the control cable of the
monitor when one of the indicators or the reverse gear is activated.
The camera whose control cable is active is always activated in automatic mode
(priority to reverse gear). If the situation arises, a switch position deviating from this is
ignored.
➤ Connect the green line of the vehicle electrics connection cable to the right indicator light.
➤ Connect the brown line of the vehicle electrics connection cable to the left indicator light.
➤ Connect the orange line of the vehicle electrics connection cable to the reversing light.
EN
Using the control box
13