Using Magicspeed - Dometic MSBE 7 Instructions De Montage Et De Service

Using MagicSpeed

10 Using MagicSpeed
You operate MagicSpeed using the control lever.
Switching MagicSpeed on and off
➤ Press the control lever once in the
✓ The LED on the control lever lights up green.
✓ You will hear two signals.
➤ When the cruise control is switched on, press the control lever again in the
switch the cruise control off.
✓ The LED on the control lever goes out.
✓ The last saved current speed will be discarded.
Saving required speeds
Use the I or II button to save two speeds in the cruise control (for example 70 km/h and 120 km/h).
A
NOTICE!
The engine can be damaged if the speed is too high. Save the required speed whilst
you are underway travelling at that speed.
I
NOTE
The control lever has two memory buttons for saving two different speeds (for example
70 km/h and 120 km/h).
➤ Press and hold down the I or II button until you hear two beeps, to save the speed you are
currently driving at.
This set speed is maintained until:
– you apply the brake or clutch pedal,
– you have switched off the cruise control or you cancel the function,
– the vehicle slows down to below the lower activation speed,
– the speed drops by more than 25% on a slope.
➤ Press the I or II button briefly to use the last saved speed.
14
direction to switch on the cruise control.
MagicSpeed MSBE7
direction to
EN