Safety And Installation Instructions - Dometic PERFECTVIEW Switch 300 Notice D'utilisation

Safety and installation instructions

2 Safety and installation instructions
The manufacturer accepts no liability for damage in the following cases:
• Damage to the product resulting from mechanical influences and excess voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
A
NOTICE!
To prevent short circuits, always disconnect the negative terminal of the electrical
system before working on the vehicle.
If the vehicle has an additional battery, its negative terminal should also be
disconnected.
A
NOTICE!
Inadequate supply cable connections could result in short circuits with the
consequence that:
• cable fires occur
• the airbag is triggered
• electronic control devices are damaged
• electric functions fail (indicators, brake light, horn, ignition, lights)
A
NOTICE!
Ensure that all lines are connected correctly. The control line may never be connected
to earth; doing so can damage the device. Make especially sure to insulate the bare
end of the control line when it is not in use and thus not connected.
Please observe the following instructions:
• When working on the following supply lines, only use insulated cable lugs, plugs and tab
sleeves.
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use terminal strips.
• Use a crimping tool to connect the cables.
For permanent connections, you can solder the cable ends together and then insulate them.
• When connecting to supply cable 31 (earth), screw the cable
– to the vehicle's earth bolt with a cable lug and a gear disc or
– to the sheet-metal bodywork with a cable lug and a self-tapping screw.
Ensure that there is a good earth connection.
8
SWITCH300
EN