Turbo Cool Operation; Sleep Operation - Sharp CV-P10PR Manuel D'installation Et D'utilisation

TURBO COOL OPERATION

The unit fan works at extra high speed with a setting temperature of 15°C.
1
Press the TURBO COOL button during
cooling mode.
• The remote control will display "
• The temperature display will go off.
• The red MAXIMUM lamp will light.
TO CANCEL
Press the TURBO COOL button again.
• The red MAXIMUM lamp will turn off.
NOTES:
• You cannot set the temperature or fan speed during TURBO
COOL operation.
• The fan returns to the HIGH speed setting after the unit has
run for 30 minutes in TURBO COOL mode.
• The extra high fan speed may automatically slow down to protect the unit.
• TURBO COOL operation and SLEEP operation can not be used together.

SLEEP OPERATION

When SLEEP operation is set, the temperature setting is automatically adjusted to prevent
the room from becoming too cold.
1
Press the SLEEP button during cooling
mode.
• The remote control displays "
• The orange TIMER lamp will light.
• The unit will stop operating after 8 hours.
• The fan speed setting is set to AUTO.
TO CANCEL
Press the SLEEP button.
• The orange TIMER lamp will turn off.
NOTES:
• One hour after the SLEEP operation is started, the temper-
ature setting rises by 1˚C and after another hour it rises by
an additional 1˚C. Temperature display on the remote control
will not change from its original setting.
• SLEEP operation and TURBO COOL operation can not be
used together.
• The TIMER OFF, TIMER ON and SLEEP operation can not
be set together. Only the most recent settings will be used.
".
".
Start of SLEEP operation
EN-13
8hours
1hour 1hour
1˚C
1˚C
Unit shuts off
1
1