NOTES
This product uses the FreeRTOS.org real
time kernel.
The FreeRTOS.org source code can be
obtained by visiting
http://www.FreeRTOS.org
FreeRTOS LICENSING:
"The FreeRTOS source code is licensed
by the GNU General Public License (GPL)
with an exception.
The full text of the GPL is available here:
http://www.freertos.org/license.txt.
The text of the exception is available on
FreeRTOS official website:
http://www.FreeRTOS.org
- License and Warranty Page
The exceptions permits the source code of
applications that use FreeRTOS soley
through the API published on this WEB site
to remain closed source, thus permitting the
use of FreeRTOS in commercial applica-
tions without necessitating that the whole
application be open sourced. The exception
should only be used if you wish to combine
FreeRTOS with a proprietary product and
you comply with the terms stated in the ex-
ception itself."
LwIP LICENSING:
"lwIP is licenced under the BSD licence:
Copyright (c) 2001-2004 Swedish Institute
of Computer Science.
All rights reserved.
Redistribution and use in source and bi-
nary forms, with or without modification,
are permitted provided that the following
conditions are met:
1. Redistributions of source code must re-
tain the above copyright notice, this list of
conditions and the following disclaimer.
2. Redistributions in binary form must re-
produce the above copyright notice, this
list of conditions and the following dis-
claimer in the documentation and/or other
materials provided with the distribution.
3. The name of the author may not be
used to endorse or promote products de-
rived from this software without specific
prior written permission.
THIS SOFTWARE IS PROVIDED BY THE
AUTHOR ``AS IS'' AND ANY EXPRESS OR
IMPLIED WARRANTIES, INCLUDING, BUT
NOT LIMITED TO, THE IMPLIED WARRAN-
TIES OF MERCHANTABILITY AND FIT-
NESS FOR A PARTICULAR PURPOSE ARE
DISCLAIMED.
IN NO EVENT SHALL THE AUTHOR BE LIA-
BLE FOR ANY DIRECT, INDIRECT, INCI-
DENTAL, SPECIAL, EXEMPLARY, OR
CONSEQUENTIAL DAMAGES (INCLUDING,
BUT NOT LIMITED TO, PROCUREMENT OF
SUBSTITUTE GOODS OR SERVICES;
LOSS OF USE, DATA, OR PROFITS; OR
BUSINESS INTERRUPTION) HOWEVER
CAUSED AND ON ANY THEORY OF LIA-
BILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLI-
GENCE OR OTHERWISE) ARISING IN ANY
WAY OUT OF THE USE OF THIS SOFT-
WARE, EVEN IF ADVISED OF THE POSSI-
BILITY OF SUCH DAMAGE."
ITALIANO
INDICE
4
INTRODUZIONE
8
IDENTIFICAZIONE DELLE
PARTI
10
INSTALLAZIONE
¦
L'installazione di queste apparecchiature
deve essere effettuata a regola d'arte, in ac-
cordo con le norme vigenti.
¦
Questo Comunicatore deve essere installato
solo da Personale Qualificato (una Persona
Qualificata ha la preparazione tecnica appro-
priata e l'esperienza necessaria per essere
consapevole, dei pericoli ai quali può essere
esposta durante lo svolgimento di un lavoro,
e delle misure per minimizzare i rischi per se
stessa e per le altre persone).
Questo Comunicatore deve essere installato e
usato solo in ambienti con Grado di Inquinamen-
to massimo 2, Categoria di Sovratensioni II, in lu-
oghi non pericolosi, al chiuso. Queste istruzioni
devono essere usate insieme al manuale d'instal-
lazione della centrale. Tutte le istruzioni presenti
in questo manuale devono essere osservate.
¦
Queste apparecchiature sono state sviluppate
secondo criteri di qualità, affidabilità e presta-
zioni adottati dalla BENTEL SECURITY srl.
¦
Si raccomanda di verificare il corretto funziona-
mento del sistema almeno una volta al mese.
Le procedure per il collaudo dipendono dalla
configurazione del sistema.
¦
BENTEL SECURITY srl declina ogni responsa-
bilità nel caso in cui le apparecchiature venga-
no manomesse da personale non autorizzato.
¦
Il contenuto di questo manuale può essere
soggetto a modifiche senza preavviso e non
rappresenta un impegno da parte della
BENTEL SECURITY srl.
Queste istruzioni descrivono
l'installazione del Modulo IP,
ABS-IP.
Per la programmazione e l'uso
delle funzioni associate al Modu-
lo, e per altre informazioni, legge-
re il Manuale Installatore e il Ma-
nuale Utente di ABSOLUTA.
I Manuali di ABSOLUTA pos-
sono essere richiesti al proprio
distributore e scaricati dal sito.
TABLE OF CONTENTS
INTRODUCTION
PARTS IDENTIFICATION
INSTALLATION
Installation of these systems must be carried
out in compliance with the local laws and by-
laws in force.
This Communicator is fixed and shall be in-
stalled by Service Persons only (service per-
son is defined as a person having the
appropriate technical training and experience
necessary to be aware of hazards to which
that person may be exposed in performing a
task and of measures to minimize the risks to
that person or other persons).
It shall be installed and used within an envi-
ronment that provides the pollution degree
max 2, over voltages category II, in non-haz-
ardous, indoor locations only. This manual
shall be used with the Installation Manual of
the alarm control panel. All instructions
specified within that manual must be
observed.
This devices have been designed and made
to the highest standards of quality and perfor-
mance.
The manufacturer recommends that the in-
stalled system should be completely tested at
least once a month.
BENTEL SECURITY srl shall not be responsible
for damage arising from improper installation or
maintenance by unauthorized personnel.
BENTEL SECURITY srl reserves the right to
change the technical specifications of this
product without prior notice.
These instructions describe how
to install the ABS-IP IP module.
For device settings and infor-
mation on how to use the mod-
ule's functions, as well as any
other information, please con-
sult the ABSOLUTA Installaer
Manual and User Manual.
The
may be obtained from your
distributor and downloaded
from the website:
www.bentelsecurity.com
ENGLISH
ABSOLUTA
Manuals