brondell FreshSpa Warm FSW-20 Guide D'utilisation page 9

Installation
4) Connect the Cold Water Bidet Hose to
Cold Water T-valve
a. Connect one end of Cold Water Bidet
Hose to the remaining open side of the
installed T-valve .
If you are only connecting the cold
water supply, then proceed to step 6.
If you wish to also connect your hot
water supply, then follow next step (5).
5) Hookup Hot Water Connection
a. Locate the warm water supply line in your
bathroom under your sink/washbasin and
turn the water supply valve all the way off .
b. Drain the warm water line by turning
on the sink tap on the warm setting until
no more water comes out .
c. Disconnect warm water supply hose
to sink from shut off valve . You may
have to use a 3/8" compatible wrench or
a similar tool (not supplied) . Note: there
may be some residual water in the hose,
use a small container or towel to catch
any residual water .
Step 4a
7