brondell FreshSpa Warm FSW-20 Guide D'utilisation page 10

Installation
d) Connect Hot Water T-valve to water supply
1 . Install the Hot Water T-valve and the small
rubber washer onto the hot water shut off
valve under the sink .
2 . Reconnect hot water supply line to open
end (top) of T-valve (use the second small
rubber washer if needed) .
e) Connect Hot Water Flex Tubing to T-valve
1 . Remove brass pressure cap from open end
of T-valve and pop out small plastic plug to
open the hole .
2 . Slide brass pressure cap over one end of Hot
Water Flex Tubing with inside screw threads
facing out .
3 . Push Hot Water Flex Tubing onto open end
of T-valve (onto the pressure connector) until
tubing cannot go any further . It's important
to make sure the tubing slides past the "lip" of
the pressure connector .
4 . Slide the brass pressure cap down the Flex
Tubing and screw onto the T-Valve until secure
and tight, use caution not to over tighten this
connection and damage the tubing!
8
Step 5d-1
Step 5d-2
Step 5e-2