Operation - brondell FreshSpa Warm FSW-20 Guide D'utilisation

Operation

Using the FreshSpa
If only connected to cold water, make sure that the temperature
dial on the bidet attachment is turned as far as it can go towards
"COLD" setting for best pressure adjustability .
For the general bidet wash function, turn the dial towards the
"Wash" position .
•
The further the dial is turned, the higher the water pressure will be .
•
To lower the water pressure, turn the nozzle back towards the center .
For a front wash function, women may need to tilt & bend forward
slightly in order for the spray to hit the appropriate areas .
To clean the bidet nozzle, turn the control dial towards the "Nozzle
Cleaning" position and water should wash over the nozzle .
To adjust water temperature (when hooked up to both Hot & Cold
connections), turn temperature dial slowly towards "HOT" until
the desired temperature is reached . Note: there may be a delay in
the warm water reaching the bidet attachment as the cold water
in your pipes clears and is replaced with hot water (same delay as
when the faucet is turned on) .
Tip: for a quick and easy way to get warm water to the bidet, run
the "Nozzle Cleaning" function with the warm water turned on for
a short time until the water heats up, then use as normal .
Caution: If connected to the hot water line, use with caution to
prevent burns or injury! Brondell is not liable for any misuse of
the product.
11