Display Information In Stand-By Mode - Ksenia lares KSI1000016.300 Manuel Utilisateur

DISPLAY INFORMATION IN STAND-BY MODE

In stand-by mode the upper line of the display shows the system status.
The informations are displayed in the following order of priority:
MAINTENANCE
TAMPER
ALARM!
MISSING PERIPH.
TAMPER
MEMORY
ALARM MEMORY
SYSTEM FAULTS
FAULT MEMORY
ENTRY TIME
EXIT TIME
WARNING TIME
PHONE CALL
ACTIVE
USB
CONNECTION
REMOTE ASS.
ZONE BYP/TEST
REMOTE
LISTENING
SYSTEM OK
maintenance by the installator. In this case no intrusion
alarm nor tamper alarm will go off.
tamper condition on at least one of the partitions enabled
an alarm is active on at least one of the partitions enabled
at least one KS-BUS peripheral is missing
tamper memory on at least one of the partitions enabled for
alarm memory on at least one of the partitions enabled for
the system has at least one fault
entry time is active on at least one of the partitions enabled
exit time is active on at least one of the partitions enabled
warning time is active on the partitions enabled for the
a telephone call is in progress
the panel is connected to the pc by USB port or a fl ash USB
key is connected to the panel
remote assistancee is enable on the panel
at least one zone is in test or manually bypassed
the remote listening from the keypad microphone is active
for the keypad
for the keypad
the keypad
the keypad
there is a fault in memory
for the keypad
for the keypad
keypad
there are no faults
lares
EN
19