Built-In Installation (With Din 503 Box) Or Directly On The Wall; Installation With Table Sustainer; Installation Notes - Ksenia ergo KSI2100000.300 Guide De Programmation

BUILT-IN INSTALLATION (WITH DIN 503 BOX) OR DIRECTLY ON THE WALL

1. Push the cable through to the proper opening.
2. Fix the keypad base to the DIN 503 box with the supplied screws opening the proper
eyelets. To fix the keypad base directly to a wall, use proper plugs (not supplied)
through the proper eyelets.
3. Connect the cables to the terminals on the rear of the keypad.
4. Fit in the PCBA on the left side of the keypad base, keeping the display in the front
and the clamps on the back, then press the right side until a double-click is heard.
5. Insert a coloured Lexan at choice into the cover.
6. Close the cover properly.
1. Install, with a light pressure, the part 1 of the table sustainer on the back of the
keypad base.
2. Fit in the part 2 of the sustainer on the part 1 by the mean of the proper hinge.
3. Push the cable through to the proper opening.
4. Connect the cables to the terminals on the rear of the keypad.
5. Fit in the PCBA on the left side of the keypad base, keeping the display in the front
and the clamps on the back, then press the right side until a double-click is heard.
6. Insert a coloured Lexan at choice into the cover.
7. Close the cover properly.
8. Use the optional cable for the programming of the communicator GSM/GPRS
gemino.
1. When ergo is switched on, the display will show the following information:
• First line: "KSENIA Security"
• Second Line: As from the first character (from the right) the FW version loaded on
the device (x.xx.xxx), as from the 10° character the device serial-number (six
numeirc characters).
This if ergo is switched on for the first time, if not connected to KSI-BUS, or if connected
to a device other than the previous one.
2. As said, ergo has been conceived to be customized using the interchangeable
Lexans provided in the original package. In order to perform the operation (the
Lexan switch) activating the "Cleaning Function" before the front removal is
suitable/advisable, and then proceed with the replacement (for further changes to
this operation please refer to gemino or lares series device manuals.
16
All manuals and user guides at all-guides.com

INSTALLATION WITH TABLE SUSTAINER

INSTALLATION NOTES

ergo