Brief Overview Of The Pictures On The Display - Siemens PolyCool Superheat - CPS40 Manuel D'installation Et D'utilisation

Picture Display
1 Display segment test for about 5 s
2 Selection of the circuit
After selecting the circuit, select the following mode with +/- and press <OK> to
confirm.
3 CONF MODE (configuration mode)
4 REFRIG (selection of refrigerant)
5 ENABLE (Enabling/disabling the compres-
sor and EIV feedback signal)
6 CAP
7 SENSOR
8 RANGE (Measurement range of X4)
9 UNITS
Continuously press <ESC> and back to picture 3
10 PARA MODE (parameter mode)
11 ΔT
ΔT SP
ΔT XP
ΔT TN
ΔT D
Continuously press <ESC> and back to picture 10
12 CAP
CAP SMX (max. setpoint increase)
CAP SD
(SD=1 indicates that 0 V / 4 mA corre-
sponds to min. cooling capacity)
CAP SP
CAP XP
CAP TN
Continuously press <ESC> and back to picture 12
48 / 120
Siemens
Building Technologies
8 Brief overview of the
pictures on the display
For the values of the setting variables and their increments, refer to
chapter 5.
(setpoint of superheat)
(6.0 K / 10.8 °F default)
(P-band superheat)
(10 K / 18 °F default)
(integral action time superheat)
(30 s default)
(D-part of superheat)
(0 default)
(18.0 K / 32.4 °F default)
(external signal direction)
(setpoint of capacity control)
(6.0 °C / 42.8 °F default)
(P-band)
(35 K / 63 °F default)
(integral action time)
(5 s default)
Superheat - CPS40

Brief overview of the pictures on the display

Procedure
Simultaneously press down +/- but-
tons for at least 5 seconds.
Set with +/- and press <OK> to con-
firm.
Press <OK> to confirm and proceed
In picture 3, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Press <OK> to confirm and proceed
Press <OK> to confirm and proceed
In picture 11, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
Press <OK> to confirm and proceed
In picture 12, set with +/-
Continue/confirm with <OK>
Exit with <ESC>
CE1U3372xx
2018-11-09