Evolution POWER TOOLS FURY3 Manuel D'instruction page 4

Table des Matières

Publicité

17. CHECK DAMAGED PARTS. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced before further use.
18. Keep hands out of path of saw blade.
19. Never reach around saw blade.
20. Turn off tool and wait for saw blade to stop before moving workpiece
or changing settings.
21. Disconnect power before changing blade, servicing or cleaning.
22. To reduce the risk of injury, return carriage to the full rear position after
each crosscut operation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
ADDITIONAL SAFETY INSTRUCTION
1.
Although compact, this saw is heavy. To reduce the risk of back injury,
get help whenever you have to lift the saw.
2.
To reduce the risk of back injury, hold the tool close to your body when
lifting. Bending your knees so you can lift with your legs, not your
back. Lift by using the handhold areas at each side of the bottom of
the base.
3.
Never carry the mitre saw by the power cord or the trigger grip of the
handle. Carrying the tool by the power cord could cause damage to
the insulation or the wire connections resulting in electric shock or
fire.
4.
Before moving the saw, tighten the slide lock knob to guard against
sudden movement.
5.
Place the saw on a secure stationary work surface and check the saw
over carefully.
6.
Warning. Do not stare directly at the laser beam. A hazard may exist
if you deliberately stare into the beam, please observe all safety rules
as follows.
The laser beam shall not be deliberately aimed at personnel and shall
be prevented from being directed towards the eyes of a person.
Always ensure the laser beam is aimed at the workpiece without
reflective surfaces, i.e. wood or rough coated surfaces are
acceptable.
Do not change the laser light assembly with a different type.
Model Fury 3
Motor (230v ~ or 110v-115v ~ 50/60 Hz) (Watts):
RPM No Load (min-1):
Recommended Maximum Duty Cycle (Minutes):
Sound Pressure Level (Under Load) (dB(A)):
Vibration Level (Under Load) (m/s
Weight:
Blade Dimensions
Maximum Diameter:
Bore Diameter:
Thickness:
Mitre
90º
45°L / 45°R
45°L / 45°R
90°
Optimum Cutting Thickness (Mild Steel Plate): (1/8") 3mm
Standard Equipment Supplied With Unit: 1 MultiBlade, 1 Box Spanner, 1
Operating Instructions.
MOUNTING THE MITRE SAW
WARNING: To reduce the risk of injury from unexpected saw movement,
place the saw in the desired location either on a workbench or other
SPECIFICATIONS
Maximum Wood Cutting Capacity
Bevel
Max Width of Cut
90°
45°
90°
45°
ASSEMBLY
):
2
220mm (8.66"")
140mm (5.51"")
140mm (5.51"")
220mm (8.66"")
4
(8-1/4") 210mm
(1")
(1/16")
Max Depth of Cut
60mm (2.36")
35mm (1.37")
60mm (2.36")
35mm (1.37")
1400
3000
30
98
1.98
12.4Kg
25.4mm
2mm

Publicité

Table des Matières
loading

Table des Matières