Wheels - Stihl MM 56 Notice D'emploi

STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
MM 56 C

Wheels

For convenient transport, the
MultiEngine can be retrofitted with a set
of wheels (special accessory).
Always use original STIHL wheels.
Using other wheels can lead to damage
to the machine and personal injuries.
Installing wheels
No additional weight is attached to the
MultiEngine
To simplify installation, turn the machine
so that it rests on the handles.
2 5
4
3 1 3
1
7
6
7
Insert the two sleeves (1) in the
N
frame
Push the frame onto the flange
N
Insert the bolt (2) with the
N
washer (3) through the hole (4) in
the flange
Fit the washer (3) and tighten it
N
down with the nut (5)
Fasten the notched plate (6) to the
N
frame with the screws (7) in the
threaded holes – in the process,
push the notched plate toward the
handle
The wheels must fold down
N
automatically in working position; if
necessary, loosen the nut (5) by a
quarter turn
Additional weight is attached to the
MultiEngine
If additional weight (special accessory) –
see "Additional weight" – is already
attached to the MultiEngine, then
additional parts are required in order to
install wheels.
In this case, have the wheels installed by
a servicing dealer.
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.
Folding the wheels in and out
The wheels can be locked in various
positions.
If the wheels are not needed during
work, fold in the wheels.
English
13