Mettler Toledo M100 SM1-wire Instructions D'utilisation page 2

–
2
Regulatory approval
FCC Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gen-
erates, uses and can radiate radio frequency energy,
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• I ncrease the separation between the equipment and
receiver.
• C onnect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
• C onsult the dealer or an experienced radio/TV techni-
cian for help.
IC Statement
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the fol-
lowing two conditions: (1) this device may not cause
interference, and (2) this device must accept any inter-
ference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de li-
cence. L'exploitation est autorisée aux deux conditions
M100 SM Series
30 370 187
M100 SM Sensor Mount Transmitters
© 09 / 16 Mettler-Toledo GmbH
Printed in Switzerland