Adjusting The Position Of The Brakes; How The Shimano Steps System Works - O2Feel Bikes Urbain Manuel D'utilisation

For stems with 4 screws, you must always
unscrew and screw in a cross pattern:
1
3

2.2 How the Shimano Steps system works

Features
• Compact, lightweight design
• Silent, smooth ride
• System o ering excellent performance in
terms of changing gears (for an electronic
shift system). This system uses accurate
sensors that let you change gear by o ering
the most appropriate level of electric
assistance, as this is carefully adjusted via
digital controls.
• Fully automatic gear changes (for a 5 or 8
Di2 electronic shift system).
The sensors detect the conditions in which
your bike is being used. If you are cycling
uphill, into a headwind, or on a flat surface
with no wind; the automatic gear shift
system uses electronic controls to make
your ride more enjoyable.
• Start mode (for an electronic shift system).
This function lets you switch to a defined
lower gear when you stop the bike, at tra c
lights for example, so that you can start o
2.1.4 Adjusting the position of
the brakes
To make sure the brake lever is in the
correct position, unscrew the brake clamp
4
and adjust the angle so that it points in the
same direction as your forearms when you
are in the cycling position.
Adjust the position so that you can apply the
brakes with two fingers.
Tighten the screws again to 5Nm. If you
want to make any other adjustments,
contact your reseller.
2
in a low gear. If you switch to a lower gear at
the set gear when the bike stops, the system
will not automatically switch to the next
gear up.
• Light o road, sports, o ers powerful
assistance. Can only be used when set up by
the bike manufacturer.
• Walk assist function (walk assist mode)
* The walk assist function may not be usable
in some regions. * Some of the functions
listed above can only be used once the
firmware has been updated. If applicable,
talk to the shop you bought your bike from
and update the firmware.
38