Preparation Before Use; Place Of Installation; Floor Protection - BH FITNESS VENICE Instructions De Montage Et Utilisation

PREPARATION BEFORE USE

Place of installation

Safety space around the chair.
At least 80 cm for the backrest between its highest and
lowest point.
At least 80cm for the footrest between its highest and
lowest point.
To avoid electrical interference the chair must be at least
1m away from television sets and radios.

Floor protection

This chair may damage the floor, so it is advisable to place a mat, for example,
under the chair to protect the floor and reduce the noise.
Unpacking the chair.-
The assistance of several people is recommended to take it out of the box.
Make sure that none of the pieces are missing.
Step 1: Fitting the backrest.-
1) Lift the backrest up vertically and lower it on to the seat
supports, fitting the flat head screws into the slot indicated on
both sides of the seat frame.
A. Flat head screw (in the backrest).
B. Slot (on the seat).
To mount the air tubes, remove the connectors (A), (B), (C), (D), (I), (J), (K)
from backrest (R) and seat (T). Connect the tubes to the armchair using the
connectors built into the tubes of the chair.
Mat
Floor
21
Fig.1