Safety Information; User Information; The Correct Helmet Position; Adjusting The Single-Hand Twisting Fastener - Crivit SP-61 Mode D'emploi

Familiarize yourself with this product before first use. Carefully read the operating instructions
and the safety information. Use the product only as described and for the indicated
purposes. Keep these instructions. If you give the product to a third party, be sure to include
all the documents with it.

Safety information

• Warning: Do not allow children to wear this helmet while climbing or playing as this
carries a risk of strangulation.
• Your helmet was specially designed for protection during cycling
skateboarding
other types of sport or for motorcycling
• Please note that the helmet can only provide protection if it fits correctly. Please
ensure you try out a range of different sizes before buying.
• Please be aware that despite correct adjustment your helmet cannot always protect
you from all injuries.
• The helmet should be checked for visible deficiencies at regular intervals.
• Following each hard impact, blow or deep scratch, the helmet must be replaced since
its protectiv effect is lost.
• The helmet must also be replaced when it no longer fits properly or no later than 3
years after the date of manufacture, even if no damage can be detected.
• Any adjustment to or removal of the original parts of the helmet can extremely impair
its protective function. The helmet may not be altered in order to make additions in a
way not recommended by the manufacturer.
• Clean the inner padding with lukewarm water and mild soap and then let it air dry.
• High temperatures, from as low as 60° C, can seriously damage the helmet. Uneven
helmet surfaces and the formation of small blisters are signs of such damage. Do not
store behind panes of glass, e.g. in the car or close to sources of heat or warmth.

User information

1. The correct helmet position

• The helmet must always be levelly horizontal on your head (Fig. A).
• If the helmet is too far forward, it can impair your vision.
• If the helmet is too far back, your forehead is not sufficiently protected (Fig. B).

2. Adjusting the single-hand twisting fastener

The integrated size-adjusting system can be adjusted using a turning knob at the back of
3 2
, roller-skating and riding a scooter
Bicycle helmet SP-61
4
. It must not be used for
5
.
5
1
,