User Information; Before The First Use; Removal And Attachment Of The Tail Light; Functions - Crivit SP-61 Mode D'emploi

LED-rear light SP-2
• If the battery leaks, avoid any contact with the skin as this can lead to skin irritation.
• Leaking batteries must be disposed of immediately.

User information

1. Before the first use

Take the tail light off the helmet (fig. J). Before the first use, remove the safety strips from the
reverse of the LED tail light (Fig. I).

2. Removal and attachment of the tail light

• To remove the LED tail light, push this upwards out of the holder (Fig. J).
• To attach the LED tail light, push this again into the holder provided (Fig. J).

3. Functions

The LED rear light has three different functions, each of which can be used as desired (Fig.
K).
• Press x1: continuous light,
• press x2: flashing light,
• press x3: colour chaser,
• press x4: light off.

4. Changing the batteries

The LED tail light comes equipped with a CR 2025 (3V) battery.
• To change this battery, unscrew the four screws on the reverse of the light with a small
screwdriver.
• Then lift the cover, exchange the batteries and put the cover back on. Ensure that the
battery polarity is correct (Fig. L).
• Now fasten the cover again with the four screws (Fig. L).
• Battery type:

5. Cleaning and care

The housing of the LED rear light can be cleaned with a damp cloth.
8