Installation Example - Fracarro COMPACT LINE SIG9606 Instructions D'emploi

3. EXAMPLES OF WALL AND FLOOR MOUNTING
The compact headend is fitted horizontally on a wall or floor as follows.
Remove the mounting brackets from the packaging and take out the compact headend.
On the cardboard packaging there are holes to indicate where to fix the brackets on the wall.
Fit the brackets using the screws from the accessory bag.
For wall installation fit the brackets as shown in figure 1 leaving enough space to disconnect the mains
cable. See figure  for floor installation.
Fig.1 Wall installation Fig.  Floor installation

4. INSTALLATION EXAMPLE

Connecting several receivers to the same antenna:
The number of receivers that is possible to connect to the same antenna depends by the frequency of
the multiplex to receive and by the level of input signal. It is recommended to program the channels
with the highest input frequencies on the first receivers of the headend. Use a splitter to divide the ca-
ble from the dish in case the signal is too high at the last input receivers.
To distribution network
15