Fracarro COMPACT LINE SIG9606 Instructions D'emploi page 18

Press any button on the numeric keypad and the message "PIN CODE" is displayed. Insert the PIN
code - the default code is 0000. To change the PIN code please see the Chapter 6.:
FRACARRO
INSERT NEW PIN
IF CORRECT
CHANNEL
SETTINGS
CU SET UP
PIN CODE MANEGEMENT AND TECHNICAL PARAMETERS
From the initial menu, you can enter the headend's configuration menu by pressing the
the cursor is on the HEADEND SETUP row.
Selecting a new PIN code:
Enter the menu "Change PIN code" and the message "Insert new PIN" appears. Enter 4 numbers and
confirm using the key
new code has been entered correctly twice.
If you forget the PIN number:
If an incorrect PIN number is entered three times the headend will lock up. You can either wait 15
minutes and try again or reset the compact headend but all existing parameters will be lost and the
headend will need to be re-programmed.
6. PROGRAMMING THE HEADEND
6.1 INSERTING A PIN CODE
PRESS ANY BUTTON
(EXCEPT )
INCORRECT
CHANNEL SETUP
>
(SEE CHAPTER 3.0)
CONTROL UNIT SETUP
>
(SEE CHAPTER 2.0)
6.2 HEADEND SETUP MENU -
. Enter the new PIN number again to confirm. The PIN will be changed if the
KEY:
= TO ENTER THE MENU
= TO EXIT
S
= TO STORE MODIFICATIONS
= ARROW DOWN
= ARROW UP
= ARROW RIGHT
= ARROW LEFT
PIN NOT VALID
AFTER 3 TIMES
RESET?
YES= NO=
YES
WAIT...
SCANS MODULES...
CHANNELS FOUND...
Press a key...
18
NO
LOADS THE
DEFAULT
PARAMETERS
(APPROX. 1 MINUTE )
key when