Product Description; Product Installation - Fracarro KSTT Instructions D'emploi

KSTT is a transmodulator able to receive a clear digital signal with a DVB-S standard coming from a satellite
antenna and modulate it according to the DVB-T standard (using the COFDM modulation).
DEMIXING OUTPUT
USCITA DEMISCELAZIONE
(verso altri moduli) (to other modules)
12V RED POWER
CAVO ROSSO PER
SUPPLY CABLE
ALIMENTAZIONE 12V
PWR ON GREEN LED
LED VERDE PWR ON
LED ROSSO ANOMALIA
TROUBLE RED LED
RJ45 PLUG FOR THE
PRESA RJ45 PER
TPE PROGRAMMER
PROGRAMMATORE TPE
INGRESSO
AUTOMISCELAZIONE
SELF-MIXING INPUT
CLIP HOOK ON DIN BAR
NOTTOLINO PER AGGANCIO SU BARRA DIN
Fig. 1
KSTT transmodulator connectors
The following is contained in the packaging:
• 1 KSTT transmodulator
• 1 RJ45 connector
• 1 spacer.
After programming the module, we recommend the RJ45 connector is left connected to avoid the build up of
dust or other particles. The unit must be installed by attaching it to the DIN bar by pulling down the clip placed
on the back of the receiver as shown in fig. 2.
The device status is signalled by 2 LEDs as shown in the following table.
Summary table of the LEDs status:
GREEN LED
OFF
ON
ON
Slow flashing
Slow flashing
Slow flashing
Rapid flashing
ON
Rapid flashing
Rapid flashing

2. PRODUCT DESCRIPTION

OUTPUT
USCITA
ALLOGGIO PER BARRA DIN
DIN BAR COMPARTMENT

3. PRODUCT INSTALLATION

4. USER'S INSTRUCTIONS
RED LED
OFF OFF
OFF Powered module and frontend hooked or TS detected
Slow flashing Powered module and frontend not hooked or TS not detected
Powered module during the interrogation phase and frontend hooked
OFF
or TS detected
Powered module during the interrogation phase and frontend not
Slow flashing
hooked or TS not detected
ON Bootloader
ON Start-up
Rapid flashing Overflow alarm
ON Trouble
OFF Module undergoing channel list update
INGRESSO INPUT
Assembling diagram of a KSTT
transmodulator on to a DIN bar
Meaning
18
MONTAGGIO SU BARRA DIN
ASSEMBLING ON DIN BAR
3
2
Fig. 2
1
KD100