Product Description; Product Installation - Fracarro SIG7404 Instructions D'emploi

The SIG7404 is an encoder for 4 analog sources. The analog input signals are carried into DVB-ASI by a BNC
connector.
Front panel
1. Display LCD
2. POWER: power LED
3. STATUS: status LED
4. ALARM: Alarm LED
5. ARROWS: up/down, left/right arrows
6. ENTER: enter button
7. MENU: menu button
Back panel
1. AV IN1: BNC connectors for analog input 1. (CVBS, R, L)
2. AV IN2: BNC connectors for analog input 2. (CVBS, R, L)
3. AV IN3: BNC connectors for analog input 3. (CVBS, R, L)
4. AV IN4: BNC connectors for analog input 4. (CVBS, R, L)
5. ASI OUT: BNC ASI output connectors (OUT1, OUT2)
6. Ethernet interface
7. Power supply
The SIG7404 module is to be installed in a 19" rack. Do not cover the device's ventilation grids; therefore, give
some space for the future presence of other modules to be kept at the correct distance (both above and below
the SIG7404 module). Install the device, connect the input and output cables and, if necessary, connect the
Ethernet port (use the description of the inputs/outputs of Chapter 2. PRODUCT DESCRIPTION).
ATTENTION: Before connecting the power supply cable, switch the encoder off by means of the power switch
(OFF).
4. OPERATION INSTRUCTIONS – PROGRAMMING BY MEANS OF THE FUNCTION KEYS
The SIG7404 module can be used with the factory default settings. To change the programming settings, use
the function keys on the front of the module. Follow the directions below.
Function keys of the front panel
MENU
ENTER
UP/DOWN arrows
LEFT/RIGHT arrows

2. PRODUCT DESCRIPTION

3. PRODUCT INSTALLATION

Back to the previous menu; cancel the parameter's settings;
Enter the selected menu, confirm and save a parameter;
To move within the menus and submenus; for changing the parameters' values
To move within the menus and submenus; to select the parameters
12