Siemens TI 905 Série Mode D'emploi page 31

Coffee has no "crema".
The coffee is too "acidic".
The coffee is too "bitter".
The coffee tastes "burnt".
The water filter does not stay in
position in the water tank.
The coffee grounds are not
compact and are too wet.
Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
The drip tray cannot be
removed.
The outlet system cannot be
assembled or disassembled.
Unsuitable type of coffee.
The beans are no longer freshly
roasted.
The grinding level is not suita-
ble for the coffee beans.
The grinding level is too coarse
or the ground coffee is too
coarse.
Unsuitable type of coffee.
The set grinding level is too fine
or the ground coffee is too fine.
Unsuitable type of coffee.
The brewing temperature is too
high
The set grinding level is too fine
or the ground coffee is too fine.
Unsuitable type of coffee.
The water filter is not mounted
correctly.
The set grinding level is too fine
or too coarse, or not enough
ground coffee has been used.
Drip tray removed too early.
The coffee grounds container is
very full.
The coffee grounds slider
becomes stuck.
Incorrect sequence
Trouble shooting en
Use a type of coffee with a higher pro-
portion of robusta beans.
Use fresh beans.
Set a finer grinding level.
Set a finer grinding level or use finer
ground coffee.
Use a darker roast.
Set a coarser grinding level or use
coarser ground coffee.
Change the type of coffee.
Reduce the temperature.
~ "Adjusting beverage settings"
on page 17
Set a coarser grinding level or use
coarser ground coffee.
Change the type of coffee.
Immerse the water filter into water until
no more air bubbles escape; insert the
filter again.
Firmly press the water filter straight
down into the tank connection.
Set a coarser or finer grinding level or
use two level measuring spoons of
ground coffee.
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.
Clean the interior of the brewing unit.
~ "Cleaning the brewing unit"
on page 26
Correctly insert the coffee grounds
slider.
Connect the outlet system (with milk
system) first, then connect the milk sys-
tem; alternatively, in the case of disas-
sembly, first remove the milk container
and then remove the outlet system.
31