Operating - Titan TP 500 Notice D'instruction

7.

Operating

Never operate the TP 500 without plastic strap; feed wheel as well as welding and
Route the TITAN plastic strap from the top around
the packing item.
Only use plastic strap which is free of grease, oil
etc.
When inserting the strap pull the end of strap
through until it is in the middle of the packing item
under the upper strap and protrudes by one length
of hand.
Use your left hand to hold both straps exactly lying
above one another.
Pull handle to the tension motor by means of
your right hand and hold it. Pull both straps to the
stop along the side of the housing wall into the
tool. Hereby, the lower strap must protrude a little
out of the tool.
Thereafter release the handle.
For tensioning the strap press push-button 1 and
keep it pressed, until the strap tension desired is
achieved.
Thereafter release push-button 1.
TP 500 II
cutting device could get damaged.
H TP 500 II EU 04/12
30 / 70