Safety Regulations - Titan TP 500 Notice D'instruction

3.

Safety regulations

Failure to comply with the following safety instructions, in addition to errors in handling the
Be informed!
Read
carefully before using the device.
Protect yourself!
Always wear eye, face and hand
protection (cut-resistance gloves)
when working.
Attention: Strap can break!
The
tightening! Do not stand in the path
of the strap. Make sure that no one
else is in the working area.
Use only original TITAN
replacement parts!
The use of other than original
TITAN replacement parts will void
the warranty and all liability.
Do not exceed air pressure!
max. 6,5 bar
Never exceed the max. permissible
air pressure of 6,5 bar.
The use of straps other than
recommended can result in broken
straps during the tightening process
and insufficient strapping. Use only
corresponding quality products
from TITAN!
Workplace!
Always
workplace. A disorderly workplace
can
operating the crimper, make sure
that you‟re in a well-braced position
in order
balance and prevent the risk of
falling. Never operate the tool in an
awkward working position!
TP 500 II
device, can result in serious injuries.
the operating manual
strap can break
maintain an orderly
cause accidents.
to maintain optimum
H TP 500 II EU 04/12
during
When
Caution: Danger of crushing!
Do not insert fingers into the pulley
area.
Caution:
Strap only objects tob e packed!
Make sure that no hands or other
body parts are between the strap
and the goods to be packaged.
Attention: Strap flies outward!
When cutting the strap, hold the top
part firmly and stand to the side.
Attention: The lower part of the
strap will fly outward.
Use only lifting gear that complies
with the safety regulations!
Do not use gas or compressed
air cylinders!
Do not connect the tool to a gas or
compressed air cylinder.
This tool may be operated only by
personnel who have been trained
accordingly. Please consult your
TITAN packaging consultant if
you have any questions about this.
Maintenance!
In order to operate safely, the tool
must be properly maintained. Check
the condition of your tool regularly
for defects or worn parts. Never use
a tool that has defects or worn
parts. Modifications to the tool are
strictly prohibited. Failure to comply
with this regulation can result in
serious injury.
26 / 70