Safety Regulations - Titan BAZ-L Notice D'instructions

3.

Safety regulations

Failure to comply with the following safety instructions, in addition to errors in
handling the device, can result in serious injuries.
Be informed!
Read
carefully
dispenser.
Attention: Strap can break!
The strap can break during
tightening! Do not stand in the
path of the strap. Make sure that
no one else is in the working
area.
Attention: Risk of cutting!
Do not put your fingers in the
cutting area.
The use of straps other than
recommended
broken
tightening
insufficient strapping. Use only
corresponding
products from TITAN!
Workplace!
Always
workplace.
workplace can cause accidents.
When operating the crimper,
make sure that you're in a well-
braced position in order to
maintain optimum balance and
prevent the risk of falling. Never
operate the tool in an awkward
working position!
BAZ-L
the operating manual
before using the
can result
straps during the
process and
quality
maintain an orderly
A disorderly
H 766 EU 37/13
Protect yourself!
Always wear eye, face and hand
protection
gloves) when working.
Attention: Strap flies outward!
When cutting the strap, hold the
top part firmly and stand to the
side.
Attention: The lower part of the
strap will fly outward.
Use
replacement parts!
The use of other than original
TITAN replacement parts will
void the warranty and all liability.
This dispenser may be operated
in only by personnel who have
been trained accordingly. Please
consult your TITAN packaging
consultant if you have any
questions about this.
Maintenance!
In order to operate safely, the
dispenser
maintained. Check the condition
of your dispenser regularly for
defects or worn parts. Never use
a dispenser that has defects or
worn parts. Modifications to the
dispenser are strictly prohibited.
Failure to comply with this
regulation can result in serious
injury.
(cut-resistance
only original TITAN
must be properly
Seite 13 von 34