Miele professional A 105/1 Mode D'emploi page 40

en - Areas of application
Middle position
Lower position
Then check
40
Move the roller brackets on both sides to the centre position and

screw them tight.
Insert the connector into the opening in the centre and click it into

place by pushing it to the left as far as it will go. Screw the con-
nector tight. Attach the blanking covers to the each of the openings
above and below, click them into place and screw them tight also.
Move the roller brackets on both sides to the upper position and

screw them tight.
Insert the connector into the opening at the top and click it into

place by pushing it to the left as far as it will go. Screw the con-
nector tight. Attach the blanking covers to the two openings below,
click them into place and screw them tight also.
Replace the upper basket on the rails and push it in carefully to

check that the water connector is positioned correctly.