MRA 10671 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Windshield
4 Metal bracket
4 Rubber screw nuts
2 M5 x 16 mm screws
2 M5 x 30 mm screws
2 15 mm spacer sleeves
4 Plastic washers 12 x 5mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the four screws and the original screen (photo P1).
3. Fasten the fixing bracket above with the long screws and the spacers, and
below with the short screws and in each case with the plastic washers.
4. Set the rubber screw nuts into the fixing bracket and turn it into the
displayed position (photo P2).
5. Set the new screen in position and fasten it with the original screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Z1000 2010-2013
Article No..
--- Allen key 3 & 4mm
10671
10629
10554
10566
10636
10635
3
Required tools