Settings; Working With The Machine - Festool SHINEX RAP 150 FE Guide D'utilisation

WARNING
Risk of injury, electric shock
Always pull the plug out of the socket before per-
forming any type of work on the machine!
Attaching polishing pads
Only use polishing pads that are suitable for the
maximum speed specified.
The polishing pads M 14 are fitted with a thread M
14 and are screwed directly onto the spindle.
Procedure
Press the spindle stop [2-1].
Turn the tool spindle [2-3] until the spindle stop
engages when pressed and the tool spindle
locks.
Screw the polishing pad [2-2] onto the tool spin-
dle or unscrew from the tool spindle.
Observe the following instructions:
– Do not use the machine when the electronics are
faulty because the machine may operate at ex-
cessive speeds. An absence of the smooth start-
up function or speed control indicates that the
electronics are faulty.
– Do not overload the machine by pressing with ex-
cessive force! The best polishing results are
achieved with moderate application pressure.
The polishing capacity and quality are mainly de-
pendent on the selection of the correct polish.
– Hold the machine with two hands, one on the mo-
tor housing and one on the gear head or addition-
al handle [1-6] to ensure safe guidance.
The rubber support points on the [4-1] provide
extra stability when the machine is set down.

Settings

2
2-3
StickFix is a system that simplifies the attachment
of polishing accessories (felt, sponge, sheepskin) to
the polishing pad [2-2] where they are retained by
an adhesive coating.

Working with the machine

4
4-1
1
2
3
Attaching polishing accessories
2-1
2-2
11