Installation
Parts supplied
The display unit
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Installation using the screw holes
on the side of this product
1 Fasten the unit to the factory radio-
mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three or
Truss head crew
four locations on each side. Use either the
(5 mm × 8 mm)
(6 pcs.)
truss head screws (5 mm × 8 mm) or flush
surface screws (5 mm × 9 mm), depending
on the shape of the bracket's screw holes.
Truss head screw or
flush surface screw
Be sure to use the
screws supplied
with this product.
If the tab interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Dashboard or console
Section
03
15
En