Installing This Product; Installation Notes - Pioneer SPH-DA100 Manuel D'installation

Section
Installation
03

Installing this product

Installation notes

Do not install this product in places subject
•
to high temperatures or humidity, such as:
– Places close to a heater, vent or air con-
ditioner.
– Places exposed to direct sunlight, such
as on top of the dashboard.
– Places that may be exposed to rain,
such as close to the door or on the
vehicle's floor.
Install this product in an area strong enough
•
to bear its weight. Choose a position where
this product can be firmly installed, and
install it securely. If this product is not
securely installed, the current location of
the vehicle cannot be displayed correctly.
• Install this product horizontally on a surface
within 0 to 60 degrees tolerance. Improper
installation of the unit with the surface
tilted more than these tolerances increases
the potential for errors in the vehicle's loca-
tion display, and might otherwise cause
reduced display performance.
60°
14
En
When installing, to ensure proper heat dis-
•
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
Leave ample
5 cm
space
5 cm