Connecting The Power Cord (2) - Pioneer SPH-DA100 Manuel D'installation

Section
Connecting the system
02

Connecting the power cord (2)

Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the parking
brake. This lead must be connected to the power
supply side of the parking brake switch.
If this connection is made incorrectly or
omitted, certain functions of this product
will be unusable.
Note
The position of the parking brake
switch varies depending on the
vehicle model. For details, consult
your authorized Pioneer dealer or an
installation professional.
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND
MUST BE CONNECTED TO THE POWER SUPPLY
SIDE OF THE PARKING BRAKE SWITCH.
IMPROPER CONNECTION OR USE OF THIS LEAD
MAY VIOLATE APPLICABLE LAW AND MAY RESULT
IN SERIOUS INJURY OR DAMAGE.
10
En
Connection method
Clamp the lead of the power supply
side of the parking brake switch.
Clamp firmly with needle-nosed
pliers.
This product
Power cord
Violet/white (REVERSE GEAR SIGNAL INPUT)
This is connected so that the this product can detect
whether the vehicle is moving forwards or backwards.
Connect the violet/white lead to the lead whose
voltage changes when the shift lever is put in reverse.
Unless connected, the sensor may not detect your
vehicle traveling forward/backward properly, and thus
the position of your vehicle detected by the sensor may
be misaligned from the actual position.
Note
When you use a rear view camera, please
make sure to connect this lead. Otherwise
you cannot switch to the rear view camera
picture.
Power supply side
Ground side
Parking brake switch