Wet/Dry Vac Assembly; Insert Hose - RIDGID WD16400 Manuel Du Propriétaire

Wet/Dry Vac Assembly

1. Line up front of Power Head Assembly
with Vacuum Inlet Port located on the
front of the Drum, as shown.
2. Place Power Head Assembly on top of
Drum.
3. Be sure Power Head Assembly
completely covers the top of the
Drum so leakage does not occur.
4. Push down on the top of the Power
Head Assembly to engage the Flexible
Locking Tabs of the Drum into the
Power Head Latch Lock Holes.
5. Make sure that the Locking Tabs are
snapped in place to prevent the Power
Head Assembly from coming off.
(See inset).
Your new Wet/Dry Vac is ready for use.
Power Head
Assembly
Latch Lock
Hole
Flexible
Locking Tab
Drum
Power Head
Assembly
Push
Down
Pull Out
Flexible
Locking
Tab
Drum
Channel
SP6975-3 16 GALLON.indb 6 SP6975-3 16 GALLON.indb 6
Vacuum
Inlet Port
6

Insert Hose

Insert the push button end of the
Tug-A-Long Positive Locking Hose into
the Vacuum Inlet Port of the Vac.
The Hose should snap into place.
To remove the Hose from the Vac,
press the release button on the Hose
Assembly and pull the Hose out of the
Vacuum Inlet Port, as shown.
Vacuum
Vacuum
Inlet Port
Port
Power
Head
Assembly
Release
Button
Tug-A-Long
Positive Locking
Hose
4/21/20 2:45 PM 4/21/20 2:45 PM