Starting Locomotive Operation; Maintenance Of The Model - Roco 2095 Série Mode D'emploi

GB

Starting locomotive operation

Unwrap model: Take out the model cautiously
with foil (fig. 1).
Operating instructions: Before use is advisa-
ble to let the loco go around about 30 minutes
forwards an 30 minutes backwards without load,
to obtain an optomal circuit and best tractive po-
wer. The smallest radius this model should run is
200 mm.
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 10002, Roco track cleaning rubber, for
remo-ving heavy dirt.
Fittings: Operation is possible with different

Maintenance of the model

To enjoy your model for a long time, it is neces-
ary to service it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Lubrication: Apply tiny oil drops to spots
marked in fig. 7. Prior to lubrication dismantle lo-
comotive (fig. 3). We recommend using item no.
10906, Roco oiler. For lubrication the gearparts
(e.g. cogwheels, worm) we whould recommended
our Roco special grease (item no. 10905).
Attention: Please do not oil these parts when
using our grease.
10
couplings (fig. 2). We recommend using the Roco
close coupling.In the enclosed accessory bag you
will find small kits to be fitted on your locomotive.
Please mount them cautiously.
Attention! Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 4.
2. Change of traction tyre: Remove the gear
cover as well as the driving rod (fig. 6). Take out
wheel set and remove traction tyre using a
pin or a fine screwdriver (fig. 5). When pressing on
the new traction tyre please avoid twisting it.
3. Carbon Brush Changing: First remove loco
body (fig. 3), and then the motor (fig. 8).
Assembly: During assembly please take care of
correct position of contacts.
Decoder interface
1
GPIO/C
P
3
Zugbus-Clock / GPIO/B
5
Masse GND
7
Front light, Drivers cab 1
9
V (+)
Twist protection
13
Front light, Drivers cab 2
15
Speaker A
17
Speaker B
19
Aux. 4 Interiorlighting, Drivers cab 2
21
Aux. 6
2
Aux. 3
16
lux
4
GPIO/A / Zugbus-Data
6
DC (+) Elko
8
Engine right (+)
10
Engine left (-)
12
Track right / Pick up
14
Track left / Tracks
16
Aux. 1 red Taillight, Drivers cab 2
18
Aux. 2 red Taillight, Drivers cab 1
20
Aux. 5 Interiorlighting, Drivers cab 1
22
Aux. 7
3